Chinese Professional Round promotion display shelving for Portugal Importers

Suzhou Innovative Store Equipment Co., Ltd. – the supplier of Timber Gondola, Cubic tower, Display showcases & counters

Providing innovative and economical fixture solutions is our goal. It’s each to configure any high impact display area with the modular design of Store Equipment’s Value Line showcases, counter wraps and registers. With even more woodgrain finishes available – you’re sure to find the perfect fit for your store’s layout.

Advantage

• Will accommodate most cash registers
• Allows for right angle counter layouts
• Great for 90 degree counters wrapping around corners, islands, etc…

What we can offer:

• Sit down Jewelry case
• Counter / Cashwrap combo
• Registers & Wrap counter
• Corner cases
• Display tables

Enjoy your patio all summer long by adding an Americana Teton Patio Cover. Patio covers from American are easy to install, especially with the help of this instructional video from Lowe’s.

Before you begin, measure the area to be covered. Then cut your post to measurement. Remember to allow for a slope. Drill holes on the awning rail. Check the instruction manual for dimensions. Slide the mounting channel into the awning rail.

Step 1 — Mounting the Awning Rail

Attach the awning rail to the structure. See the manual for the type of screws needed. Apply silicone to the back side of the entire rail.

Step 2 — Attaching the Two Roof Panels

Attach the panel on each side to the awning rail. Check the manual for screw type. Don’t tighten the screws yet. Slide in the Styrofoam flashing plug to prevent water leaks.

Step 3 — Attaching the Header Beam to the Posts

Attach the post brackets to the beam. Check the manual for spacing recommendations. Slide the posts in place and attach them to the bracket on both sides using screws. Do the same for the other side.

Step 4 — Attaching the Beam and Posts to the Roof Panel

Stand the beam and posts upright with the roof panels sitting lightly on them. You can do this one at a time if it is easier for you. Set your measurements for the placement of the beam. Check the manual for recommendations. Attach the roof panel to the beam. Make sure the posts are level. Mark the position. Place the bracket in position and mark the holes for drilling. Drill all four holes. Place the bracket back in position. Place the concrete anchors in the holes.

Be sure to watch the second part of this instructional video for the final steps of assembling your patio cover. Shop patio covers at Lowe’s: https://www.Lowes.com

Subscribe to Lowe’s YouTube for great how to videos and home improvement tips: https://www.youtube.com/subscription_center?add_user=lowes

Or head to our channel: https://www.youtube.com/Lowes